-
-
Print Carriage (top) 13A (1x)
-
M3x12 button head cap screw (1x)
-
M3 Square Nut (1x)
-
-
-
Insert M3 square nuts into carriage top and bottom.
-
Insert M3x12 screw into print carriage base.
-
-
-
Print carriage (bottom) 14A (1x)
-
Mini V Wheel (3x)
-
M5 5.6mm Spacer (6x)
-
M5x30 button head cap screw (3x)
-
M5 Nylock Nut (3x)
-
OpenBuilds precision shim (x6)
-
-
-
Y Carriage (top) L 15A (1x)
-
Y Carriage (bottom) L 16A (1x)
-
Mini V Wheel (2x) OpenBuilds Precision Shim (4x)
-
F623ZZ Bearing (4x)
-
M5x35 button head cap screw (2x)
-
M5 Nylock Nut (2x)
-
M3x30 socket head screw (2x)
-
M3 Nylock Nut (2x)
-
-
-
Y Carriage (top) R 17A (1x)
-
Y Carriage (bottom) R 18A (1x)
-
M5x12 button head cap screw (1x)
-
M5x10 button head cap screw (1x)
-
M5 T Nut (2x)
-
-
-
Partially thread M5x10 into M5 T nut.
-
Partially thread M5x12 into M5 T nut.
-
-
-
Y Carriage (top) with hardware (1x)
-
Y Carriage (bottom) with hardware (1x)
-
Mini V Wheel (2x) OpenBuilds Precision Shim (4x)
-
Belt Pulley (4x)
-
M5x35 button head cap screw (2x)
-
M5 Nylock Nut (2x)
-
M3x30 socket head screw (2x)
-
M3 Nylock Nut (2x)
-
-
-
Insert M3 Nuts into Print Carriage (bottom) for later mounting of part cooling fan.
-
Insert M5x10 screws into F11. These will be used for pre-loading the carriage later.
-
-
-
Y Carriage Assembly (left) (1x)
-
Y Carriage Assembly (Right) (1x)
-
Print Carriage Assembly (1x)
-
F11 with hardware (1x)
-
M5x35 button head cap screw
-
M5 Nylock nut
-
-
-
Slide Y Carriage Assembly (left) on to extrusion F11
-
Fasten Carriage to through hole in F11 with M5x35 screw and nylock nut
-
F11 sticker should be on top face at other end of F11
-
-
-
Roll on print carriage
-
Pay attention to orientation of carriages on F11. Sticker should be on top face
-
Slide Y Carriage Assembly (Right) on to F11 and tighten screws lightly
-
Cancel: I did not complete this guide.
4 other people completed this guide.