-
-
I made a quick video to show how to preload the BareXY. See link below
-
-
-
-
-
Insert belt through belt lock
-
Fold belt back on itself so teeth interlock
-
Slid belt lock over end of belt
-
-
-
Attach lower belt to belt pin
-
Attach upper belt to belt pin
-
Insert belt pin into print carriage
-
-
-
Top belt is shown as red and bottom belt is shown as blue in models
-
Feed each belt along the paths as shown
-
-
-
After feeding belts through belt path fasten belts to belt pin with belt locks like we did earlier in step 3 and 4
-
Feed belt pin into slots on right side print carriage
-
-
-
Make sure screws are loose enough that the motor assembly can slide
-
Place belt around pulley
-
Slide motor back applying tension to belt
-
Tip: belts should be taught but not excessively tight
-
While applying tension to belt, tighten motor mount
-
Tight motor mount with tensioned belt
-
Same process for top and bottom belts
-
Cancel: I did not complete this guide.
4 other people completed this guide.