-
-
E3D Hotend (1x)
-
BondTech Extruder (1x)
-
M3x40 screw included in BondTech extruder kit (3x)
-
-
-
Mount BondTech and stepper motor using M3x40 screws (supplied with your BondTech BMG)
-
-
-
Feed BLTouch wires through the same hole as the hotend wires
-
-
-
Part Cooling Fan Shroud 27A (1x)
-
50mm Blower Fan (1x)
-
M3x25 socket head screw (1x)
-
M3x12 socket head screw (2x)
-
M3 Nylock nut (1x)
-
-
-
Press fan into position
-
Fasten fan to shroud with M3x25 screw and M3 nylock nut
-
Assembled fan with shroud
-
-
-
Mount cooling fan assembly with M3x12 screws
-
Screws thread into nylock nuts embeded in the print carriage
-
Correctly mounted cooling fan assembly
-
-
-
Move carriage left up against hard stop
-
Shift bed left or right so that the side of the bed (red) lines up with BLTouch probe (blue) when carriage is against hardstop. Once lined up tighten bed in place
-
Probe tip should be above edge of heated bed
-
-
-
Make sure screws are loose enough that the aligners can be shifted
-
Center FlexPlate in relation to bed
-
Slide aligners inward until up against FlexPlate
-
Tighten aligner mounting screws
-
Cancel: I did not complete this guide.
3 other people completed this guide.