-
-
Spool Holder 19A (1x)
-
M5x10 button head cap screw (2x)
-
M5 Drop-in T Nut (2x)
-
-
-
Bowden Tube Holder 20A (1x)
-
Bowden Coupling (1x)
-
M5x10 screw (1x)
-
M5 Drop-in T-Nut (1x)
-
-
-
Press Bowden Coupling into Bowden Tube Holder 23A
-
Mount bowden tube holder assembly to frame using M5x10 screw and drop-in T-nut (exact position not important)
-
-
-
Pulley Bracket (top) L 21A (1x)
-
Pulley Bracket (bottom) L 22A (1x)
-
Belt Pulley (4x)
-
Pulley Spacer 3mm (1x)
-
M3x30 socket head screw (1x)
-
M3 Nylock Nut (1x)
-
-
-
M5x10 button head cap screw (x2)
-
M5 drop in T nut (x2)
-
Pulley bracket assembly left (x1)
-
-
-
Mount Pulley Bracket to frame using M5x10 screw and drop-in T-nut
-
Mount Pulley Bracket to frame using M5x10 screw and drop-in T-nut
-
Shown mounted on printer
-
-
-
Pulley Bracket (top) R 23A (1x)
-
Pulley Bracket (bottom) R 24A (1x)
-
Belt Pulley (4x)
-
Pulley Spacer 3mm (1x)
-
M3x30 socket head screw (1x)
-
M3 Nylock Nut (1x)
-
-
-
M5x10 button head cap screw (x2)
-
M5 drop in T nut (x2)
-
Pulley bracket assembly right (x1)
-
-
-
Mount Pulley Bracket to frame using M5x10 screw and drop-in T-nut
-
Mount Pulley Bracket to frame using M5x10 screw and drop-in T-nut
-
Location on printer for reference
-
-
-
Line V wheels up with V slot vertically then pivot into position. (Y carriages should be loose enough to pivot slightly)
-
Tip: be gentle with gantry while it is still loose and could fall out. It will be solid after preloading is done later
-
-
-
Printed Logo 28A (1x)
-
M5x8 button head cap screw (2x)
-
M5 Drop-in T Nut (2x)
-
Cancel: I did not complete this guide.
4 other people completed this guide.